The drive shaft bellows sleeve installation tool is used to install the aluminum ring into the Alpha 1 Generation 2, Bravo, Blackhawk U-joint bellows.
|
|
|
|
---|---|---|---|
STEP 1Apply Bellows Adhesive to Gimbal Housing. |
STEP 2Put the Aluminum Rings into Gimbal Housing. |
STEP 3Then put the Bellow Retainer Ring Install tool in and fix it slightly. |
STEP 4Use the engine alignment tool hammer in it! |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
|
---|---|---|---|---|---|---|
Shift Cable Tool Socket 91-12037 & Hinge Pin Tool 18-9861 | Lower Shift Cable Kit 865436A02 | Propeller Wrench B3DUL Double Hex Prop Wrench 8M0129074 | Prop Wrench/Bearing Carrier Retainer Nuts Installer/Bearing Carrier Tool | 21970 Trim Connector Assembly Kit | Bearing Retainer Spanner Wrench & Carrier Retainer Wrench Tool | |
Fitment | Shift Cable Tool Socket 91-12037 -- Fit for Mercruiser MC-1 , R , MR , for Alpha One Gen I & Gen II. Use with 18-2190 and 18-2190E cables. | Fits for Mercruiser Stern Drives All MC-l, MR, (for)Alpha One and (for)Alpha 1 Gen 2 1978 & Newer. | Fits for both of the MerCruiser Bravo III prop nuts. One wrench fits both prop nuts. One end is suitable for 1-7/16" outside nut; the other end is suitable for huge 2-3/4" inner nut. The 1/2" drive torque wrench socket is located at the 1-7/16" end. | Fit for Mercruiser All Bravo lll Drives | Fit for MerCruiser: (for)Alpha One GEN ONE TWO sterndrives (1972-1990) and for MerCruiser R/MR/Bravo Drives 1983-Up. For The Hydraulic Trim Hoses On most (for)Mercruiser Outdrives That Use 1/4" Tube Fittings From 1983 And Newer. | Fits for all mercruiser Alpha one, for Pre Alpha, for Generation 2, for Bravo One, for Trs outdrives and will also fit for Mercury / Mariner outboards 150HP and up.(Note: Will not fit for Bravo 2, 3, XR, or TR.) |
Hinge Pin Tool 18-9861 -- Suitable for all marine push plate tail drives: for Alpha One, for Alpha One Gen II, for BRAVO I, II & III along with MC-1, R & MR. |