INSTALLATION
An 10mm electric drill is required during installation, if you don’t know how to use the electric drill, we advise you ask a professional or experienced person to install it, because the wrong installation would damage your wall.
Here are the installation instructions:
1. You need to plan the installation location first to determine where the bracket is fixed (a hard wall is recommended).
2. You need a 10mm electric drill to drill holes at the confirmed position. Please note that the depth of the hole is consistent with the length of the bolt.
3. Embed the entire set of expansion screws into the hole.
4. Tighten the nut. When you feel that the screw is tight, it will not loosen, then unscrew the nut. Then align the holes on the mounting bracket with the screws, and finally tighten the nuts.
NOTE:
1. During installation, do not tighten the screws on the back of the mirror to facilitate adjustment of the mirror angle.
2. There is a transparent protective film on the mirror, please be sure to remove it after installation. (If removed prematurely, the mirror may be scratched during installation.)