Feature

●The Infrared Emitter is based on the infrared emission infrared emission control module 940, the infrared signal emitted by the transmitter tube 940nm wavelength, the signal can be acquired infrared receiver module is a few meters away and demodulation, encoding and decoding process can be achieved with the remote control function.
●The Infrared Receiver is based on HL-A838 integrated infrared receiver modules, IR transmitter module can receive incoming 38KHz modulated infrared signal, and demodulated into logic level, When it receives the modulated infrared signal then output low level, otherwise output high level. IR remote control can be completed by using application of codec.
●The infrared receiver module and transmitter module can complete the infrared remote control with the codec program.The transmitting angle is about 45 degrees and the receiving angle is about 90 degrees.
●The transmitter module:power supply can be 5V or 3.3V.You can manually adjust the direction of the launch tube according to the actual application requirements.The infrared receiver module:power supply voltage can be 3.3V ~ 5.5V.Low-power, wide-angle and long distance reception;Output matching TTL, CMOS level.
●Note: there is no modulation circuit in the transmitting module. When used on mega2560 motherboard: the program does not need to be modified. The transmitting module is connected to pin 9 of mega2560 motherboard and the receiving module is connected to pin 2 of another motherboard.


Description

Specifications:
Infrared Emitter module:
Operating Current:50mA (max)
SIG pin current:High lelel 0.4mA (max),low level 1.4mA (max)
Compa Compatibility:Arduino UNO R3 / Arduino Mega2560 and other microcontroller board
Control interface: a total of 3 pins (GND, VCC, SIG), GND is the ground, VCC is the power supply, and SIG is the signal input pin
Infrared emitting tube: can emit infrared signals with a wavelength of 940nm
Groove: It is convenient to manually adjust the direction of the infrared transmitting tube
Positioning holes: 4 M2 screw positioning holes with a hole diameter of 2.2mm, which makes it easy to install and locate the modules and realize the combination between the modules

Infrared Receiver module:
Operating Current:2mA (max)
Size:2.4x2.4cm/0.94x0.94inch
Control interface: a total of 3 pins (GND, VCC, SIG), GND is the ground, VCC is the power supply, SIG is the signal output pin
Integrated infrared receiver: demodulate infrared signal modulated by 38KHz square wave
Positioning holes: 4 M2 screw positioning holes with a hole diameter of 2.2mm, which makes it easy to install and locate the modules and realize the combination between modules

We highly appreciate all customers opinions to improve the selling, also if anything you unsatisfied, please contact us for probable best solution.

Package Includes: 1Set
1x Infrared Emitter module
1x Infrared Receiver module