Feature

●THE initial state of the output from the two depends on the tilt sensor is turned on and off, when turned on, the green light, the output low, the tilt sensor is disconnected, the green light is off, the output is high;
●THE tilt sensor is generally in the initial state are installed in the normally open state, the tilt sensor is not in working condition and prolong life;
●THE output relay module can directly drive the shop, which can form a high-power angle control switch;


Description

1, the use of the companys SW-520D tilt sensor sensitivity
2, the comparator output signal clean, good waveform, driving ability, than 15mA.
3. Distribution bit sensitivity adjustment
4, operating voltage 3.3V-12V
5, the output format: digital switching output (0 and 1)
6, a fixed bolt holes for easy installation
7, a small PCB board size: 3.2cm x 1.7cm
8, using a wide voltage comparator LM393