Feature

●Lamp ID:5J.JEE05.001
●Compatible with BenQ HT2050,HT2150ST,HT3050,W1110,W1120,W1210ST,W2000,W2000+ Projectors,with Housing
●We use A++ quality wicks that provide higher brightness and better color contrast with a life span of up to 3000-3500 hours.
●Installing the projector light is very easy and will only take you a few minutes.
●We offer up to 200 days after-sales guarantee, any problem with the projector lamp, you can contact us for exchange or refund.


Description

High Quality Projector Lamps with Housing

RLC-092RLC-092
RLC-092RLC-092

Projector Lamp Type: Projector lamp with Housing/Cage

Wattage:P-VIP240W

Specification:E20.9n

Compatible with Benq Projector models: HT2050,HT2150ST,HT3050,W1110,W1120,W1210ST,W2000,W2000+ Projectors

Package Included

1* Projector Bare Lamp Bulb with Housing/Cage

RLC-092RLC-092

Step 1. Unplug the power cord from your projector and let the lamp cool down.

Step 2. Locate the lamp access panel on your projector and remove the screws and access panel.

Step 3. Remove any screws holding the lamp housing into the projector.

Step 4. Reach in and firmly pull the lamp housing out of the projector.

Step 5. Place the new lamp housing into the projector in the same orientation as you removed the old lamp.

Step 6. Wiggle the lamp into place and make sure full contact is made inside of the projector.

Step 7. Replace the lamp mounting screws to secure the lamp into the projector.

Step 8. Replace the lamp access panel and secure the screws.

Step 9. Plug in your projector and power it on.

Step 10. Reset the lamp counter. Some lamps will reset the lamp counter automatically when a new lamp is placed in.

RLC-092RLC-092

RLC-092RLC-092

RLC-092RLC-092

Where is My Projector Lamp Located

A projector lamp can be found by locating a square or rectangular plastic plate somewhere on the outside of the projector; the plate is usually on the bottom of the projector, but can sometimes be found on the top or sides.

This cover is usually secured by two screws; undo these screws and lift the plate off to reveal the bottom of the plastic housing (the module) that holds the projector lamp in place in your projector.

This plastic housing usually has a handle attached to it. Pull gently on this handle to remove the projector lamp from your projector.

It is time to replace the lamp when:

* Picture has become dull and lacks brightness.

* There is an obvious decline in picture clarity and sharpness.

* Your lamp is flickering.

* There is difficulty or a delay when turning the machine on.

* A light comes on that warns you that it may be time to change your lamp.

Note:

1. Let the lamp cool down before replacing it.

If the lamp breaks, handle the shards

carefully to avoid injury.

2. Do not touch the glass portion of

the lamp assembly. Touching the glass

could result in premature lamp failure.

3. Be sure to seat the lamp fully and

secure the lamp cover. If the lamp is

not properly installed or the cover

is loose, the lamp will not turn on.