1. A cooling tank (barrel) of more than 8 gallons is needed.
2. CONNECT the heater body and the submersible pump with a silicone hose. Place the submersible pump in the cooling bucket, connect the power supply of the pump, and wait for the water to circulate out. (Note: the water temperature of the machine will keep rising for a long time. Please replace the cold water clearly. the temperature of the circulating water should not drop abruptly. When the water temperature exceeds 120 degrees, the power supply of the heater should be cut off in time, and replace water.)
3. CONNECT the thermostat with the hot bender. Adjust the temperature. Clockwise is to raise the temperature. Dont rotate too fast to damage the thermostat. (Note: Excessive temperature will cause damage to the hot bending material and affect the service life of the hot bender).
4. WHEN the heating pipe reaches the required temperature, place the plastic sheet which needs to be hot-bended on the heating trough. When the sheet is soft enough to be folded manually, it can bend at various angles.