How to measure the length of the required belt:

1. Wrap the rope around the two pulleys
2. Make a mark
3. Place the marked rope on a flat surface and use a tape measure to measure the distance between the two marks, which is the inner circumference of the belt

• To accurately measure the length of the v-belt, use a belt measuring tool or a soft ruler, not a steel ruler.
• The width and thickness of the belt should also be measured to confirm the type of belt.

Installation:

• First, loosen the tensioning device, then press the v-belt into the pulley groove by hand, and finally tighten it again.

Notice:

• Pay attention to the wear of the belt groove of the v-belt pulley.
• Check whether the centerline of the two pulley shafts is parallel, whether the corresponding pulley slots are aligned, and whether there is any skewing phenomenon.
• When one v-belt is badly worn and cannot be used, replace all the v-belts at the same time, with the same type and equal length, so that each belt has the same tension.

Maintenance:

• Regularly check the v-belt tension, after adjustment still can not meet the specified requirements, must be replaced with a new v-belt.
• In use, the operating temperature of the v-belt should not exceed 140°F, do not apply belt grease casually.
• Various types of v-belt, should not be coated with rosin or sticky substances, but also to prevent v-belt pollution on the oil, butter, diesel and gasoline, otherwise, it will corrode the v-belt, and shorten the service life.
• V-belt should be stored at a relatively low temperature, with no direct sunlight and no oil and corrosive fumes place.