Feature
●?Compatible with OPTOMA DH1010 EH1020 EW615 EX612 EX615 GT50E GT50ECA GT750 HD1081 HD180 HD20 HD200X HD200X-LV HD20-LV HD22 HD2200 HD23 PRO800P SP.8EG01GC01 SP.8MY01GC01 TH1020 TW615-3D TX612
●? Compatibility: （VIP 180/0.8 E20.8）is compatible for most housings which the house matched with your accurate projector models.This bare bulb is an universal product for the projectors.
●?All lamps are produced by our own factory
●?All Lamps Will Be Test Before Delivery, All Messages Will Be Respond Within 24hours, Excellent Return Service And Friendly Customer Service
●?Safety: Higher temperature resistance with optimized buner design.Light weight and compact reflector lamps with ECG.Uniform light output throughout the entire lifetime.
[Bl-fp230d-cb]
[Bl-fp230h]
Description
Projector Lamp Type: Projector Bare lamp
Model number: BL-FP230D BL-PH230H Bulb Osram P-VIP 230/0.8 E20.8
Compatible with Projector models: Optoma DH1010 EH1020 EW615 EX612 EX615 GT50E GT50ECA GT750 HD1081 HD180 HD20 HD200X HD200X-LV HD20-LV HD22 HD2200
Step 1. Unplug the power cord from your projector and let the lamp cool down.
Step 2. Locate the lamp access panel on your projector and remove the screws and access panel.
Step 3. Remove any screws holding the lamp housing into the projector.
Step 4. Reach in and firmly pull the lamp housing out of the projector.
Step 5. Place the new lamp housing into the projector in the same orientation as you removed the old lamp.
Step 6. Wiggle the lamp into place and make sure full contact is made inside of the projector.
Step 7. Replace the lamp mounting screws to secure the lamp into the projector.
Step 8. Replace the lamp access panel and secure the screws.
Step 9. Plug in your projector and power it on.
Step 10. Reset the lamp counter. Some lamps will reset the lamp counter automatically when a new lamp is placed in.
|
|
|
|
|---|---|---|
Where is My Projector Lamp LocatedA projector lamp can be found by locating a square or rectangular plastic plate somewhere on the outside of the projector; the plate is usually on the bottom of the projector, but can sometimes be found on the top or sides. This cover is usually secured by two screws; undo these screws and lift the plate off to reveal the bottom of the plastic housing (the module) that holds the projector lamp in place in your projector. This plastic housing usually has a handle attached to it. Pull gently on this handle to remove the projector lamp from your projector. |
It is time to replace the lamp when:* Picture has become dull and lacks brightness. * There is an obvious decline in picture clarity and sharpness. * Your lamp is flickering. * There is difficulty or a delay when turning the machine on. * A light comes on that warns you that it may be time to change your lamp. |
Note:1. Let the lamp cool down before replacing it. If the lamp breaks, handle the shards carefully to avoid injury. 2. Do not touch the glass portion of the lamp assembly. Touching the glass could result in premature lamp failure. 3. Be sure to seat the lamp fully and secure the lamp cover. If the lamp is not properly installed or the cover is loose, the lamp will not turn on. |
