The Beadsmith EZ-Hook jewelry helper was designed for hard-to-close jewelry, zippers, buttons and cufflinks.
Part of the Jewelry Aid line, which was designed to correct and repair common jewelry related issues, the hook is a 3-in-1 too solution to everyday issues. It is made of stainless steel and includes a clip, an eyelet and an extender with a 20-inch reach. The EZ Hook is very each to use. As a bracelet fastener, attach the clip to eyelet or open end of the bracelet. Place tool in hand with palm facing up & clip pointing toward elbow. The bracelet should dangle from the thumb side of your hand. Hold clasp end of bracelet with free hand and attach to eyelet or open end of bracelet. Release clip after clasp is secured. To use as a zipper assist, it’s suggested to remove the rubber tips from the clip for a better grip. Attach clip to zipper tab. Holding gripper at opposite end of grip, reach behind and pull to extend the tool, pulling up on zipper tab to close. Pull down on zipper tab to open. When finished opening or closing zipper, detach clip from zipper and place rubber tips on clip.