Feature

●BN-280 gps module has flash to save configuration, so you do not need to reset data next time when you use it. But it has no compass. If you need gps with flash and compass, please buy bn-880 or bn-880q from Geekstory
●When you use it for Raspberry Pi, there is no driver needed but you need to install software. Receiver mode: GPS,GLONASS,Galileo,BeiDou,QZSS and SBAS; 72 search channel
●Blue light, TX light, the upper blue light is flashing, indicating data output. Red light, PPS light, not positioned this light does not light; after 3D positioning, start flashing
●Data Level : TTL or RS-232,Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable
●The product documentation link cannot be displayed. If you need technical documentation, please click “Geekstory”(you can find "Sold by Geekstory" under Buy Now button), in the new page, click “Ask a question” to email us.


Description

Description:
Chip: U8 (M8030-KT)
Receiver mode: GPS, GLONASS, Galileo, BeiDou, QZSS and SBAS
Frequency: GPS L1, GLONASS L1, BeiDou B1, SBAS L1, Galileo E1
72 search channel
Baud rate: 4800bps-921600bps, 9600bps by default
Output level: TTL or RS-232, TTL by default
Output agreement: NMEA-0183 or UBX, NMEA-0183 by default
Single: GNSS:1Hz-18Hz
Standard: GNSS:1Hz-10Hz,1Hz by default
Size: 28*28*10 mm

Mod ule pin
1.PPS, Sec pulse will output after positioning, pulse period is 1s, high level persists 100 ms, used for system synchronization
2.GND, connect to the ground
3.TX data output of module
4.RX data input of module
5.VCC, 3.0V-5.5V, recommend 5.0V
6.BOOT

Package Includes:
1 X BN-280 GPS module
3 X Cable