Feature

●BG86 Ignition Coil Replaces: 4241-400-1320 /4241 400 1320/ 42414001320.
●Used on Stihl BG56 BG56C SH56 BG86 BG86C SH86 Blower.
●This armature magneto is an authentic manufacturer sourced replacement part. It is specially produced for use with Stihl leaf blower. The ignition module provides current for the ignition system by producing pulses of high voltage for the spark plugs.
●Package include: 1 ignition coil,It is made out of metal with rubber cord insulation. HIPA-Fixing machines can be Easier.Trust Hipa to keep your outdoor power equipment running like new.
●100% Satisfaction Guarantee, 90 days return, refund or free exchange if you arent completely satisfied (defection, accidental damage, non-satisfaction etc.) Please verify your engine model and part numbers before purchasing to ensure you receive the correct parts.Any problem please do not hesitate to contact us.


Description

Hipa bg86 Ignition Coil

hipa Ignition Coilhipa Ignition Coil
bg86 blowerbg86 blower

this part fits the following stihl blower :

  • Ignition Coil Replaces: 4241 400 1320/ 42414001320.
  • Fits for Stihl BG56 BG56C SH56 BG86 BG86C SH86 Leaf Blower.

Please note replacing the module would differ based on your unit, however the basic steps would be the same.

? Remove the housing/covers from the unit

? Remove the spark plug

? Bind the cylinder

? Remove the air filter cover and side cover

? Remove the throttle cable from the carburetor

? Disconnect the wires

? Remove old ignition coil

? Install new ignition coil

? Reassemble and test the unit

The Notices During Installation

  • Please check the kill-switch wire and make sure it is connected right otherwise there will be no spark if this is not connected correctly.
  • When installing the new ignition coil, make sure to rotate the flywheel into a position where the magnets on the flywheel face the ignition coil.
  • Using a folded piece of paper to adjust the correct gap between ignition coil armature and magnet.
  • When tightening the screws of the ignition coil, ensure that the flywheel can still rotate freely.
  • Check again that the kill switch wire is still correctly connected and didnt come loose in the process.

stihl ignition coilstihl ignition coil