Feature

●【8-Pack Replacement Kits】4.5cm*6.5cm rectangular metal plate x 4 Pieces,round metal plate with a diameter of 4cm X 4 Pieces
●【Material】The product is made of high-quality manganese steel material and the matte surface is easier to clean than ordinary ones.
●【Thin&Practical】The thickness of the product is only 0.5mm, which is light and practical.The metal plate is very thin and light.3M adhesive works well and is easy to install.
●【Use For Magnetic Mount】Metal plate is mainly used for magnetic phone support, it without magnetic.3M adhesive on the back of the sheet metal, used in the fixed plate of the back of the phone.
●【Tip】 The metal plate do not with magnetic.The metal plate is design for magnetic car phone holder and can work well for it.

[8-PACK]

Description

Widely compatible

Compatible with Various Types of Magnetic Phone Holders

Various Location: Air Vent / CD Slot / Dashboard / Windshield / Suction Cup / Cup Car Mount/Bicycle / Vehicle / Universal and all Magnetic Phone Mount.

Compatible with Popsockets Grip

1. Only 1.57 Round Mount Metal Plate can Work for Pop sockets Grip.

2. Only Stick on Outside of the Callapsible Grip & Stand, NOT Inside.

3. Easy Use: Pop out the Grip, Stick the Plate onto the Cap, then it is Compatible with Magnetic Mount.

4. Super Thin, almost NOT Add the Thickness of POPsockets.


Strong Adhesive 1.The back of the metal plate with strong adhesive, it make the metal plate will not easy to fall off.	Super Thin 2.It is very thin and can better fit the surface of the phone or phone case.Widely Compatible with ALL Smartphones without Textured / Curved Surface.	Work Great 3.Work great with Magnetic Mobile Phone Car Mounts

HOT NOTE

1. AVOID AFFECTING WIRELESS CHARGING, Please Place Metal Plate on the Phone AWAY FROM WIRELESS CHARGING SENSOR;or Place Metal Plate on Phone Case,Please Remove the Phone Case before Wireless Charging.

2. These Metal Plates with 3M Adhesive Can NOT be Reused after Removaled, Can NOT Used as Toys for Babies and Children.

3. All of the Metal Plates have no Magnets, and They Do Not Have any Magnetism.It just Replacements Plates for Magnetic Car Mounts.

4. Not Recommend to Apply on the Leather / Silicone / Soft Case, or with Textured / Curved Surface.If the Back of the Phone isCurved Glass, it is Recommended to Stick the Metal Plate on the Flat and Smooth Phone Case.

Installation of the metal plate


Step 1 Clean and Dry the Surface of your Phone / Phone Case with the Alcohol Pack.	Step 2 Tear off the Transparent Protective Film and Stick it on the Back of Phone or Phone Case	Step 3 Peel Off the Sticker and Place the Metal Plate on the Transparent Protective Film of the Phones / Cases Surface.Adhere with Finger or Hand Pressure on it for Consistent 20 Seconds.	Step 4 Suggest you Wait for 24 Hours before Using to Make Sure it Firmly.Use Hair Dryer to Blow Hot Wind on it to Melt the Adhesive to Remove it.