Feature

●Chuck weighs 1.2 lbs., and is 2.5" in diameter.
●The jaws will secure blanks up to 1" across, and 4" long.
●The chuck is pre threaded to 1" x 8 tpi to match your spindle.
●Includes two tommy bars to tighten and loosen the jaws.

[Standard Capacity]

[Large Capacity]

Description

Drill a perfectly centered hole in your pen blank directly on your lathe. Thread chuck onto your lathes headstock spindle. Mount a drill bit in a drill chuck in your lathes tailstock. Advance drill bit into blank while lathe is spinning. Chuck is pre-threaded to 1" x 8tpi. Weighs 1. 2 lbs. Diameter 2. 5". Chuck will secure blanks up to 1" square x 4" long. Dedicated jaws are 2" long. Includes (2) tightening levers to open and close the chuck jaws.