Feature

●? AnyTone Smart Power output: 15 Watts FM/ AM PEP. The default frequency 28.000-29.700Mhz (10 meter Radio) with 40 channel, fully alloy body, stronger and efficient radiating. Small Size. Automatically Squelch and manual squelch control.
●? GREAT LITTLE RADIO Modulation Mode:AM/FM, it sounds very loud and very clear. Great super small mobile radio. It is good for fitting in any vehicle or radio shack or ATV. It is great for a holiday road trip or for local traffic reports.
●? Frequency Control: PLL Synthesizer. With push-to-talk/UP/DN and coiled cord AnyTone Smart 10 Meter Radio is for truck
●? WARRANTY: 1 year warranty. Money back if you are not satisfied with it in 1 month. Please feel free to contact with us if you have any query. We will give you prompt reply and good after service


Description

AnyTone Smart 10 Meter Radio for Truck, Small Size,AM PEP Power Over 16W

CB RADIO SMARTCB RADIO SMART

SPECIFICATION

AnyTone Smart 10 Meter Mobile Radio is complied with Federal Communications Commission (FCC) regulations. FCC ID is T4K-SMT02

GENERAL

  • Modulation Mode AM/FM
  • Frequency Range 28.000-29.695MHz
  • Frequency Tolerance ±5.0ppm
  • Input Voltage 13.2V
  • Dimensions 109x104x25mm
  • Weight 421g
  • Ferquency Control PLL Synthesizer
  • Operating Temperature Range -20℃ ~ +50℃
  • Current Drain
  • Transmit 2A MAX
  • Receive Squelched 0.3A
  • VOL Max 0.8A
  • Antenna Connector UHF,SO-239

TRANSMITTER

  • Power Output 8 Watts FM/AM
  • Transmission interference inferior to 4nW(-54dBm)
  • Frequency Response 300-3000Hz
  • Modulated signal distortion inferior to 5%
  • Output Impedance 50 ohms

RECEIVER

  • Sensitivity Less than 1uV for 10dB(S+N)/N
  • Image Rejection 70dB
  • Adjacent Channel Rejection 60dB
  • IF Frequencies
  • 1st 10.695MHz
  • 2nd 455KHz
  • Automatic Gain Control(AGC) Less than 10dB change in audio
  • Output for inputs from 10 to 50000uV
  • Squelch less than 1uV
  • Audio Output Power 1Watts
  • Frequency Response 300-3000Hz

WARNING

  1. Your equipment is protected against an inversion of polarities. However, before switching it on, you are advised to check all the connections. Your equipment must be supplied with a continued current of 12 volts (A)
  2. Lorries generally have two batteries and an electrical installation of 24 volts, in which case it will be necessary to insert a 24/12 volt converter into the electrical circuit. The following connection steps should be carried out with the power cable disconnected from the set. a.)Check that the battery is of 12 volts. b.) Locate the positive and negative terminals of the battery (+ is red and ? is black). Should it be necessary to lengthen the power cable, you should use the same or a superior type of cable.

Looking for specific info?

See questions and answers