Feature

●【Scope of application】Cylinder honing tools are suitable for degreasing engine cylinders with diameters from 3/4 in to 2?1 / 2 in and 1?1 / 4 in to 3?1 / 2 in. The manufacturers part number is 88233
●【Excellent performance】This tool can be used to remove carbon deposits and hot glaze in the cylinder bore. This special tool can be used for small-bore cylinders, such as motorcycles, brakes, and clutch cylinders, ideal for removing rust deposits in old renovations.
●【High quality】The cylinder honing three jaws are made of high-quality iron materials, high strength, high hardness, rust and resistance, not easy to wear and not easy to age, and are made of special technology to enhance their stability and performance to ensure excellent durability and long service life .
●【Ergonomics design】The engine cylinder grindstone adopts ergonomics design, which can be comfortably held, effortless to use, easy to operate, labor-saving, and high-efficiency, bringing you a lot of convenience. Flexible shaft, easy to use, and automatic centering. The knurling wheel can adjust the spring pressure of the stone on the cylinder hole.
●【Use steps】Spray lubricant on the stone or cylinder hole. Set the whetstone on the drill bit, insert the engine whetstone into the cylinder, and then run the drill bit at a low speed of 300-700 RPM. Move the bone left and right every second, and never push the stone more than 3/4 inch away from the cylinder. The engine hone time should not exceed 3 minutes, after honing, wipe the inside of the drum with a paper towel.


Description

Specification:
Condition: Brand New
Item Type: Cylinder Honing Tool
Material: Iron
Manufacturer Part Number: 88233
Range: Approx. 50-170mm/2-6.7in
Usage:
Step 1.
Spray lubricant on the stones or the cylinder bores. Get the hone set up on the drill.
Step 2.
Insert the engine hone into the cylinder and run the drill at low speed between 300-700 RPM. Move the hone up and down around once a second.
Dont push or pull the stones more than 3/4 inches out of the cylinder. Dont run the engine hone for more than 3 mins.
Step 3.
After honing, use a paper towel to wipe out the inside of cylinder.

Package List:
1 x Cylinder Honing Tool