Fitment :
Function :
|
|
|
|
---|---|---|---|
STEP 1Apply Bellows Adhesive to Gimbal Housing. |
STEP 2Put the Aluminum Rings into Gimbal Housing. |
STEP 3Then put the Bellow Retainer Ring Install tool in and fix it slightly. |
STEP 4Use the engine alignment tool hammer in it! |
Tool Used for Removal and installation of Hinge Pin from Drives. Specifically used on hinge pin bolts and separate the housing from the gimbal ring.
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
|
---|---|---|---|---|---|---|
For Mercruiser Mercury Hinge Pin Tool 18-9861 | Bellow Retainer Ring Sleeve Installation Tool | Gimbal Bearing Alignment and Install Kit | Gimbal Bearing Installer/Puller Remover & Enigne Alignment Tools& Hinge Pin Tool | Trim Tilt hydraulic Ram Cylinder hose kit | 21970 Trim Connector Assembly Kit | |
Fitment | Suitable for all marine push plate tail drives: for Alpha One, for Alpha One Gen II, for BRAVO I, II & III along with MC-1, R & MR. | Fits for Alpha 1 Generation 2, for Bravo, for Blackhawk U-joint bellows. | suitable for Mercuiser Alpha, for Alpha 1, for MR, for Bravo,for OMC, for Cobra and for Volvo and so on. | Gimbal Bearing Installer Bearing Puller: Fits for Mercruiser Alpha, for Alpha 1, for MR, for bravos, for OMC cobras and for Volvo. (note: A hole needs to be drilled in the alignment tool to install the universal bearing driver.) | Fits for all Alpha drives 1991 and newer. Also suitable for Alpha One Gen One & two which is have trim cylinders 16-3/16". | Fit for MerCruiser: for Alpha One GEN ONE TWO sterndrives (1972-1990) and for MerCruiser R/for MR/for Bravo Drives 1983-Up. For The Hydraulic Trim Hoses On most Mercruiser Outdrives That Use 1/4" Tube Fittings From 1983 And Newer. |
Hinge Pin Tool: Suitable for all marine push plate tail drives: for Alpha One, for Alpha One Gen II, for BRAVO I, II & III along with MC-1, R & MR. |