Feature

●? BENEFITS: Fully retractable tie down anchors, snaps up and down, and sits flush on the rail cap. Sold as a pair thats great for optimizing truck bed storage.
●?? HIGH QUALITY: Fully retractable tie down anchors for truck bed made from high quality materials. Nylon lower body with sound dampening, a factory look that matches the exact grain and color of Ford rail caps.
●?? STRONG & SECURE: 1,000 lbs capacity, stainless steel ring, stainless steel chassis, no rust, no rattle. Matches color, texture & UV rating of OEM rail caps. Serviced in the USA, lifetime “no bull” warranty.
●FITMENT GUIDE: These Bull Ring truck tie down anchors are the perfect fit for (front or middle) for 1998-2014 Ford F150 Trucks & 1998-2016 Ford F250 & F350 Super Duty Trucks.
●?? EASY TO USE: Fully retractable, flush fit, snaps up, snaps down. Fits S hooks & ratchet straps. Perfect for camping, moving & hauling. Easy installation in 30 seconds or less, no drilling, no special tools & no modification.

[Rear for 6  & 8  beds (1 Pair)]




[Rear for 6  & 8  beds (2 Pair)]




[F150 with 5   Bed   &  Ford Raptor (1 Pair) W  &  Router]




[F150 with 5   Bed   &  Ford Raptor (1 Pair)]




[Front  & Middle for 6  & 8  beds (1 Pair)]





Description

Serviced here in the USA. At Bull Ring you can depend on a lifetime of service. That is our promise.

Bull Ring’s are the premium tie-down anchor points for your truck.

While the stock anchors points are inside the bed where it’s hard to reach, Bull Rings retractable anchor points easily install into the stake pockets on top of your bed rails. Simply pop the stainless steel ring up when you want to use it to secure a load, then hit it down flush when you don’t. Each is made from stainless steel and glass reinforced nylon for a 1000 lb. capacity, no rust and no rattle. Bull Ring’s stainless steel tie down anchors are essential truck accessories for optimal truck bed storage.

40384038
installationinstallation

Installation (after modification):

  1. Remove screws from anchor
  2. Insert base into stake pocket
  3. Place bottom of stainless steel backing plate into hole
  4. Insert screws and pull outward on ring while turning screw
  5. Just before snug, center the anchor in hole
  6. Once the screws are tight, give the screws one last 1/4 turn
  7. Do not over tighten - avoid power tools and ensure screws are only hand tight

misalignedmisaligned

Example of an Offset Stake Hole Pocket

Here is an example of an offset/off-center stake hole. For stake hole pockets that resemble this, use this model #4038.

Product information