[1-48 Spline to 3  & 4 Smooth]

[3  & 4 Smooth to 3  & 4 Smooth |  HSB]

[5  & 8-36 Spline to 3  & 4 Double D]

[3  & 4-30 Spline to 3  & 4 Smooth]

[3  & 4 Smooth to 3  & 4 Smooth]

[3  & 4 Smooth to 3  & 4 Double D]

[3  & 4 Smooth to 1 Double D]

[5  & 8-36 Spline to 3  & 4 Smooth]

[9  & 16-26 Spline to 1 Double D]

[3  & 4-36 Spline to 3  & 4 Smooth |  HSB]

[3  & 4 Double D to 3  & 4 Double D]

[9  & 16-26 Spline to 3  & 4 Smooth]

Brand New Steering Universal Joint (SWS Part # 105-9255).

• These are brand new steering joints produced by Southwest Speed.
• It is always a good idea to replace the universal joint when doing any work on the steering system.
• Southwest Speed Steering Universal Joints are manufactured using the highest quality materials available, and are built to handle the abuse from high horsepower applications.
• Replacing the universal joints is an inexpensive way to refresh the steering system.
• NOTE: When using more than two universal joints in a system, a support heim must be used.

  Features:

  • High strength needle bearings
  • Built to handle the vibrations from racing applications
  • Working angle up to 30 degrees
  • High quality fasteners designed for better attachment and upgraded safety

    Specifcations:

    • Joint Type: Single
    • Finish: Black Oxide
    • Material Type: Steel
    • Side # 1: 9/16"-26 Spline
    • Side # 2: 3/4" Smooth

      In order to determine which u-joint you will need, you can follow these steps:

      • Determine which spline is on your steering box or rack. You can measure and count, or use the chart shown in the images
      • Then, determine which steering shaft you have, or will need for your specific application (3/4" Smooth, 3/4" Double D, or 1" Double D)
      • NOTE: Increasing a U-Joints angle of operation beyond 30° dramatically increases the stress on the joint, weakening the entire steering mechanism.
      • If a greater angle is needed, add another u-joint.