Product Description:
voltage：6-60V
High Power:400W
Maximum current: rated 16A peak 20A
support PLC 0-5V analog control
support PWM control
amplitude 2.5-5V
note: this driver is only suitable for DC brushless Hall with an electrical angle of 120 degrees motor.
MA MB MC phase line output to motor
5V GND The motherboard comes with a 5V power supply
VCC GND main power supply
SC speed pulse signal output
DIR direction control Forward and reverse control interface
STOP stop Stop control interface
BRAKE brake control brake control interface
Speed control and speed control signal input
Ha Hb Hc +5V GND Hall signal Power supply input interface, generally motors with Hall have corresponding 5 wires
There are 5 Hall wires on the brushless motor, two of which are Hall power wires. The three Hall signal wires must be distinguished, especially the power wires must not be mistaken. The order on the board must match the order of the three-phase wires on the motor driver board to work properly. If the three hall signal wires run smoothly, the low-speed start is smooth and the torque is large.
Note: If you dont know the definition of Hall wire, please use low current and low voltage to test the first wiring tester, change the sequence of hall wire until normal operation, and then turn on high current and high voltage after confirming, otherwise there is Risk of damage to the driver board. At the same time, pay attention to the insulation of the wiring head when wiring. During normal operation, the motor output has sampling over-current protection. Since the power and current of the module are very large, please do not short-circuit when the module is not working normally.
Package Included:
1*DC 6-60V 400W Three Phases Hall Brushless Motor Controller Board