Specification
- Main Material: Aluminum + Steel
- Threading Range: 20.9-49.6mm/0.5-2in
- Power Type: Alternating Current
- Color: Orange
- Rated Power: 2300 (W)
- Voltage: 110 V, 60 Hz
- Rated Spindle Speed: 25 (r/min)
- Dies Diameter: 15,20,25,32,40,50mm (1/2", 3/4", 1", 1-1/4", 1-1/2", 2")
How to Use
1. You should select the corresponding die head. The blade is installed from the right on the host.
2. Clamp the tube to approximately the same length as the arm (L2 is approximately equal to L1).
3. Turn the front and rear switches to the down arrow position to start the switch and auxiliary contacts.
4. For hard pipes such as stainless steel pipes, galvanized pipes, brass when refueling in time, and plastic pipes without fuel.
5. Note that the tube holder can not be touched with the host during the right shift, otherwise it will hurt the host.
6. After the machine stopped, pull up the reverse switch and exit the tube.
7. This product supports the use of standard tubes.