|
|
|
---|---|---|
1. NOTE:Only tighten the bolt finger tight at this stage. |
2. Using the special tools, turn the center bolt of the special tool with a maximum of 5 Nm (44 lb-in) of torque to push the clutch down to release the pressure from the hollow input shaft snap ring. |
Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer. Torque : 44 lb.in (5 Nm) |
|
|
|
---|---|---|
NOTICE: Make sure the lifting legs are installed on the clutch studs marked with the stamped manufacturing mark as shown. NOTICE: Installing the lifting legs on unmarked clutch studs will damage the pressure plate adjuster. NOTICE: Make sure the lifting leg with the angle is in the location shown. Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer. |
Turn the center bolt with approximately 5 Nm (44 lb-in) of torque until the clutch is free of the input shaft. Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer. Torque : 44 lb.in (5 Nm) |
|
|
|
|
---|---|---|
Remove special tools. Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer. |
Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer. |
NOTICE: Do not overtighten the special tool or damage can occur. Use Special Service Tool: 307-675 Fixture, Clutch Remover/Installer. Torque : 44 lb.in (5 Nm) |
DPS6 Clutch Tool Transmission Installer Remover Tool for Ford Volvo Focus Fiesta | DPS6 Clutch Tool Transmission Seal Installer Remover Tool for Ford Focus | |
---|---|---|
Fitment | for Ford Focus Festiva DCT | for Ford Focus Festiva DCT |
Function | DPS6 transmission installer remover tool. | Use this tool to remove & install the input seal . |
Material | Steel | Steel |