How to install ignition CDM module 114-7509 ?
- Disconnect and clean all engine and battery ground wires
- Disconnect the old CDM Module and remove the high tension coil wire from the spark plug
- Unbolt and remove the old CDM Module. (Note the direction of the spark plug wire)
- Check for dc voltage on the kill (stop) wires (usually black/Yellow) with the key switch in the on and off position.
- Apply a slight amount of dielectric grease to the seal area of the wire connector from the engine harness
- Apply a slight amount of dielectric grease to the outside of the new spark plug wire and thread the spark plug wire into the new CDM Mod
- Bolt the new CDM Module onto the engine(orient the new CDM Module so that the spark plug wire is pointed in the same direction as the original)
- Plug in the connector from the wire harness into the new CDM Module and connect the spark plug wire to the spark plug