Feature

●High-quality material-This rear wheel axle bearing puller kit is made of high-quality steel, having a polish surface.
●Good performance- The bearing puller kit enables you to remove and reinstall almost any bearing and ABS tone ring (reluctor),it will fit any symmetrical 4-bolt circle from 100mm to 140mm with 10mm or 12mm studs.
●Vehicle fitment- Fit for:Toyota 4Runner 1996-2002; Toyota Hilux 2004-2012; Toyota Tacoma 1995-2004; Toyota T100 1995-1998; 2000-2006 TOYOTA TUNDRA. And it will fit any symmetrical 4-bolt circle from 100mm to 140mm with 10mm or 12mm studs.
●Package content- Axle bearing puller,adapter plate,40mm bearing driver and ABS tone ring.
●Wide application- Replacing Rear Axle Seal & Bearing on a 1st gen Tacoma w/ABS (or 3rd gen 4Runner).


Description

How to use this puller kit?

Toyota 4Runner, Tacoma, Tundra, FJ, Hilux, Sequoia, T100 and some Lexus from 1984 to present. These models all use unit bearings. Depending on how corroded onto the axle the bearing is, and how worn the bearing is, the outer race and housing may separate from the inner race while pressing. This will require the inner race to be cut off. This situation is not the fault of the tool and is not a valid reason for return of this item.

Also, it will fit any symmetrical 4-bolt circle from 100mm to 140mm with 10mm or 12mm studs.

For vehicles with external ABS tone rings:

Fit for Toyota 4Runner 1995-2020

Toyota Hilux 2004-2012

Toyota Tacoma 1995-2004

Toyota T100 1995-1998

Toyota Tundra 2000-2006

Warm prompt:

The tone ring tool does not fit 2001-2007 Sequoia. The tool only fits those vehicles listed above.

This bearing puller and installer kit only works with the 40mm bearing and tone ring that is separate from the housing. It is not intended for the larger unit bearings used on later generation vehicles.

A longer bolts will be required to use for Toyota Tacoma.