Feature

●1. Power the receiver after connecting the signal line of ESC to the receiver, and ensure the receiver and RC are well bound.
●2. Cut off the power of the ESC, and push the stick upwards. Power the ESC again and calibration is done via RC.
●3. Calibration mode can be identified by the sound of motors. Push the stick downwards to change the mode.
●4. One parameter changes each time. If you cannot tell from the sound of the motors, please cut off power and repeat step 1.
●5. Push the sick downward under "RESET" mode, and all parameters will revert to default mode.


Description

Throttle range calibration

*please calibrate the throttle range when you use a new ESC or RC.

*When an abnormality occurs, or a higher rotation speed is required, please try changing timing parameters.

*High timing, automatic braking, and intermediate acceleration is the default setting,

Protections

This ESC is specially designed for multi-rotors.

Start-up Protection: The ESC will shut down the motor when it fails to start the motor normally in 2 seconds by increasing the throttle value. In this case, you need to move the transmitter throttle stick back to the bottom position and restart the motor. (Possible causes: poor connection or disconnection between ESC and motor wires, propellers and blocked, etc.)

Throttle signal loss protection: When the ESC detects a loss of signal for over 0.25 seconds, it will cut off the output immediately to avoid greater loss which may be caused by the continuous high-speed rotation of propellers or rotor blades. ESC will resume the corresponding output when normal signals are received.

Motor lock-up protection: The ESC will try to restart the motor (thrice)when motor lock-up is detected, if it fails, it will cut off the output and stop attempting. To restart the ESC and resume its output, you need to push the throttle stick to the bottom position and then start again.

Over-load protection: The ESC will cut off its output immediately when the peak current gets close to 340A(short-circuit current). Please regain its normality by powering it on.