[Screw Mount]

[Adhesive Mount]

The ModTX LED flush-mount doorbell reflects simplicity and modernism. The all-metal push button responds with a soft click, surrounded by a thin illuminated halo and mounted inside a 1/4 inch thick, matte black, solid aluminum panel. The ultra-efficient LED emits a bright glow even in daylight, using less than one watt and lasting approximately 10 years. A perfect gift for your DIY homeowner, designer or architect.

Install it yourself: Two post terminals easily connect to low voltage doorbell systems. The panel is corrosion resistant, cut from 6061 aluminum alloy, and finished in flat black. Cuts and finishes may contain small imperfections, and vary in fit and finish from the images shown.

OPTIONS
Clean mount (3M): Includes durable 3M weather-resistant outdoor mounting tape for use on smooth, clean surfaces.
Screw mount: Includes two black stainless, semi-countersunk screws (#8 x ~1″). Screws might not line up with existing wall holes.

REQUIREMENTS:
Wall opening required: 5/8″ (16mm) wide. Back of buttons will recess 1.1″, (1.4″ deep with wiring).
Universal compatibility. Fits all wired 12-24 volt doorbell systems such as Nicor Primechime, Heath Zenith SL-27102-02 or Vercoma bell pusher systems.

SPECIFICATIONS:
IP67 Waterproof
Panel dimensions: ~4″ tall x 1.25″ wide x 1/4″ thick
Panel is corrosion resistant, 6061 Aluminum alloy
Made in USA of U.S. and imported parts. Cut, polished and assembled in Texas.
Includes a one year replacement warranty on lighted button module from date of purchase.