Feature(may vary by option.)
●Water Resistance Level: Not Water Resistant
●Built-in Amplifier - With a MOSFET power supply you get improved switching speeds, better performance with less power from the driver, lower gate-to-drain feedback capacitance, lower thermal impedance for higher switching frequencies
●PWM - Pulse Width Modulated design simplifies power supplies. It controls the output voltage and current precisely by removing the output current sensing loss & eliminating all secondary feedback circuitry. It’s efficient & reliable
●Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filters frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s)
●High Level Inputs - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the US10 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs
●Low-Level Inputs - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the US10 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers
●Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it
[8 Inch + Wire Kit]
[8 Inch]
Description
Break Your Subwoofer In
Much like the engine of a new automobile, a new subwoofer must go through a short but important process of “break-in” before it is run under harsh conditions. The “break-in” process will ensure the subwoofer is able to perform as it has been designed to.
This process involves subjecting the subwoofer to no more than low-to-medium volume levels for a number of hours in the enclosure. 3-4 hours is generally sufficient for the subwoofer’s suspension to loosen enough to prevent the voice coil(s) from overheating and causing failure.
The break-in period is also effective in extending subwoofer life. Over-driving the woofer before it has been properly broken-in will usually result in premature failure and poor performance.
- 10-inch subwoofer, Built-in class A/B amplifier, MOSFET power supply
- Soft turn-on circuit, RCA (low) & speaker (high) level inputs
- Thermal, short and overload protection circuit
- Green LED power status indicator, red LED protection status indicator
- Subwoofer level control, switchable phase shift selector switch: 0 or 180º
- Variable low pass crossover: 50 – 150 Hz
- Variable bass boost: 0 – 12 dB, variable input gain control, speaker impedance: 2.6 ohms
- S/N ratio: 90 dB, frequency response: 30 – 150 Hz
|
|
|
|
|
|---|---|---|---|
Built-In AmplifierSystems with a built-in amplifier do not require the addition of an external amp. They already have the power to play louder. |
High and Low Level InputsHigh-level inputs accept speaker output signals and low-level inputs accept pre-amp output signals to allow for the addition of amps and processors to standard factory or aftermarket source units. |
MOSFET Power SupplyMetal Oxide Semiconductor Field-Effect Transistors quickly switch from full to non-conduction for high efficiency output. |
Class A/BOur Class-A/B amplifiers feature specific linear circuitry that increases sound quality and power output while reducing distortion and improving efficiency. |
|
|
|
|
|
|---|---|---|---|
Variable Low Pass FilterVariable low-pass filter gives you control over the frequencies that pass through to the subwoofer. |
Variable Bass BoostVariable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it. |
Phase ControlPhase control lets you switch the speaker phase with the amp if your speakers or subwoofer are hooked up out of phase. |
Short ProtectionAutomatic shut-off protects the amplifier if it gets too hot or if speakers fail causing a short. |
