Installation Instructions:
Step 1: Make sure your windows are thoroughly cleaned.
Step 2: Spray the windows with A LOT OF soapy water.
Step 3: Measure the exact dimensions of your windows and carefully cut the film to the right size.
Step 4: Remove transparent backing film from the backing protect the sheet, and spray A LOT OF soapy water onto the back side of the static film.
Step 5: Pick up the wet film by the top two corners to paste the wet side of the film onto the wet grass, and smooth the film with your hands.
Step 6: Spray the water onto the surface facing you, and use the squeegee to remove extra water and air from the center with proper strength.
Step 7: Make sure the four corners are steadily adhered to the glass, trim off the margins, leaving a 2-3 mm gap from the edge of the glass to the film.
Step 8: Rewet the surface of the entire film and remove all the bubbles, wipe out surface water with a lint-free towel.
Useful Tips:
Keep the window and film extremely wet during the installation process. If it becomes dry, re-wet it completely before applying the film.
Before pasting, do remember to tear off the protective film ( transparent film).
Spray more water on the glass and surface of the film, the more water, the better, and scrape all the bubbles out with a squeegee.
Leave about a 2-3mm gap between the window frame and the film to avoid falling off or curling; if there shows falling or curling, pick up a corner at the edge, re-spray and paste, and scrape the bubble.