Feature

●Material: Finely polished stainless steel frame with knurled thumb roller and locking screw ensure smooth sliding and accurate positioning in use
●Specification: Accuracy ±0.001"/ ±0.02mm, measurement range 0 - 6"/ 0 - 150 mm, resolution 0.0005"/ 0.01mm, accurate measurement, suitable for home or DIY measurement
●Purpose: Digital caliper measuring tool with two sets of jaws and a probe can be used to measure inner and outer diameters, depths and steps
●Easy to Read: The digital caliper has a large easy-to-read display screen, which is easy to read clearly. You can get accurate measurement results more conveniently and quickly
●Measurement Mode: One click to quickly switch between two measurement modes: inches and millimeters. This product also has the zeroing function, you can press the "zeroing" button at any position of the measurement, easily zeroing and start a new measurement


Description

0-6 Inch Electronic Digital Caliper

11

  • 0-6 Inch Metrics Calipers Rulers 150 Millimeters Dimensional Measuring Tool

22

Operating instructions

Before Using

  • Before using this caliper for the first time, wipe the rust preventative oil over the caliper using a soft cloth.
  • Remove battery compartment lid and insert SR44 battery with its positive (+) side facing upward.

Operating Instructions

  • For absolute measure ment- after turning unit on, close jaws and press ZERO switch. The 0.00mm or 0.000in display appears, indicating origin (absolute zero) setting is completed. The caliper is now ready for absolute measurements.

For Comparison Measure Ment

  • In the boot state, place the caliper claw on the reference measuring surface and press the ZERO switch. The 0.00mm or in 0.000 display appears, indicating zero setting is completed. The caliper is now ready for comparison measurements.

Specifications

  • Resolution: 0.01mm/0.0005 inch
  • Repeatability: 0.01mm/0.0005 inch
  • Maximum Measurement Speed: 1.5m/s 60in/s
  • Operating Temperature: 0℃ - 40℃
  • Power: 1.5v SR 44 (silver oxide cell)
33
44
5-15-1

External Diameter

  • Measure the outer diameter or length of an object with two long jaws. Clamp the object between the two parallel sides of the long jaw and fix it in place

5-25-2

Internal Diameter

  • Measure the inner diameter of the object with two short jaws. Place the two short jaws in the subject and roll the thumb roller close to the inside diameter of the subject

5-35-3

Step

  • Measure the step with two short jaws. Place the caliper vertically on the surface and roll the thumb wheel until the lower part of the upper short jaw is parallel to the step

5-45-4

Depth

  • Measure the depth of the object with a long probe at the end of the caliper. Insert the probe into the object and roll the thumb wheel to measure its depth