Feature(may vary by option.)
●Optimized for Engagement, Access, and Strength – Our deep, 6-point design maximizes your contact with fittings and prevents slipping
●Reinforced Jaw Strength – We reinforced our wrenches with material where it matters most to avoid high stress concentrations and prevent the jaws from spreading
●15-Degree Offset Increases Access Angles – The jaw opening is offset 15 degrees from the center of the wrench so that it can be flipped over to gain additional access angles
●Electroless Nickel Plating for Corrosion Resistance – The electroless nickel plating finish is easy to wipe clean, highly resistant to corrosion, and has a low environmental impact compared to conventional hexavalent chrome plating
●Uniform Coverage and Better Fit – The electroless plating process applies a uniform coating to the entire tool surface; by comparison, electroplating, including conventional chrome plating, has varying thickness across the tool because the plating thickness depends on the electric current density at each point on the tool
●Manufactured in Michigan – Tekton flare nut crowfoot wrenches are made entirely in the USA with USA-sourced materials; most of the steps, including machining, broaching, blasting, plating and engraving, take place at Tektons manufacturing facility in Grand Rapids, Michigan
[8 mm Metric]
[11 & 32 in. Inch]
[8 & 16 in. Inch]
[19 mm Metric]
[5 & 16 in. Inch]
[10 mm Metric]
[14 mm Metric]
[7 & 16 in. Inch]
[27 mm Metric]
[1 & 2 in. Inch]
[17 mm Metric]
[23 mm Metric]
[3 & 8 in. Inch]
[1-1 & 16 in. Inch]
[15 & 16 in. Inch]
[20 mm Metric]
[1 in. Inch]
[12 mm Metric]
[13 mm Metric]
[13 & 16 in. Inch]
[9 mm Metric]
[3 & 4 in. Inch]
[15 mm Metric]
[11 & 16 in. Inch]
[22 mm Metric]
[5 & 8 in. Inch]
[21 mm Metric]
[7 & 8 in. Inch]
[16 mm Metric]
[24 mm Metric]
[11 mm Metric]
[18 mm Metric]
Description
Tekton Flare Nut Crowfoot Wrench sizes scale optimally with fitting depths to achieve the best possible combination of engagement, access, and strength. Our design is leaner than conventional 6-point crowfoot wrenches, giving you more room to work in tight spaces. The wrenches are abrasive blasted to create a smooth, satin finish. Our electroless nickel plating process applies a uniform, corrosion resistant coating to the entire tool surface. Each crowfoot wrench has a permanent high-contrast size marking engraved on the side. The wrenches are made entirely in the USA with USA-sourced materials. Most of the steps, including machining, broaching, blasting, plating and engraving, take place at Tektons manufacturing facility in Grand Rapids, Michigan.