· Level 3 is enough for most applications; thicker the bag, higher the level required
· The red light is not predictable when plug into the power. It is only predictable when keep the handle pressed down on bottom. This is a protection for sealer
· When seal is done, the red light will go off. Dont release the handle at once and keep the handle pressed down for a few seconds to get optimal results. If you use a 12-inch sealer, please put your hand on the middle of the handle would be better
· Replacements should be replaced when the PTFE (cloth) appears warn, discolored or sealing isnt perfect
· Never wipe the heat seal strip with a wet cloth
|
|
|
|
---|---|---|---|
Step 1Plug into the power |
Step 2According to the thickness of bags, adjust the sealing timer to 1-8; and level 3 or 4 is enough for most bags; Thicker the bag, higher the level required |
Step 3No warm-up time needed, Just put the bag on the machine flat |
Step 4Press dawn the sealing machine’s arm. When the signal light is off automatically, keeping the handle pressed down for a few seconds would get optimal results |
|
|
|
|
---|---|---|---|
1.Using the tools to loosen the screws on the sealing machine |
2.Remove the old heat sealing strip and heating element |
3.Install a new heat sealing element |
4.Then tighten the screws |