Feature
●60 amp Solar Charge Controller: 12V/24V DC (Automatically detects systems voltage). Max.PV input voltage is 50V. Compatible with various Deep Cycle battery options: Sealed, Gel, Flooded
●Positive Ground Charge Controller 60A: 3-Stage intelligent PWM charging: Bulk, Boost/Equalize, Float; Multiple Load mode: Light control, Light Time control,Dual Time control
●Solar Charge Regulator Built in LCD display design, dynamically displaying all operating datas and working condition; humanized button for more comfortable and convenient operation
●Multiple protection against overcharge, over discharge, over load, short circuit, reverse polarity, over heat and battery under voltage;
●Professional after-sales customer service, Heat sink design for achieving higher heat dissipation. Extensive electronic protection and battery temperature compensation function.
[60A]
Description
Step: Connect the system in the order of 1.battery-->2. load-->3.PV array, and disconnect the system in the reverse order 3. 2. 1.
Wiring:
- Please always connect the battery before connect the soalr panel, disconnect in reverse order. And pay much attention to the “+” and “-”
- Battery must be connected first !!!
- DO NOT connect any inverter/ wind/ Alternator or Charger into the charge controller! If an inverter is to be connected to the system, connect the inverter directly to the battery.
- If the remote temperature sensor is not connected to the controller, the default setting for battery charging or discharging temperature is 25 °C without temperature compensation.
- The wire size is only for reference. If there is a long distance between the PV array and the controller or between the controller and the battery, larger wires can be used to reduce the voltage drop and improve performance.
- The battery fuse should be installed as close to battery as possible. The suggested distance is within 150mm.
Setting: 1. Accumulative power zero clearing: Under PV power interface, press SET button and hold on 5s then the value blink, press SET button again to clear the value. 2. Setting temperature unit: Under battery temperature interface, press SET button and hold on 5s to switch.
