HP LaserJet Enterprise M607, M608, M609, M610, M611, M612, M612; HP LaserJet Managed E60055, E60065, E60075, E60155, E60165, E60175 - Removal and replacement: Tray 1 pickup roller
J8J70-67903 Tray 1 Kit
HP LaserJet Enterprise M607, M608, M609, M610, M611, M612, M612; HP LaserJet Managed E60055, E60065, E60075, E60155, E60165, E60175 - Removal and replacement: Trays 2-x rollers
J8J70-67906 Tray 2 roller kit Removal and replacement User Manual
1:OPEN THE PAPER TRAY TO LOCATE THE ROLLERS
2:OPEN THE PAPER TRAY TO LOCATE THE ROLLERS
3:Tray 2 rollers only: On the back side of the printer, open the rear door.
4:Tray 2 rollers only: Raise the transfer assembly.
5:Tray 2 rollers only: Do the following:
6:Tray 3 rollers only: On the back side of the printer, open the rear lower cover.
7:Tray 3 rollers only: Do the following:
8:Remove the orange separation roller tool from the packaging.
9:LOCATE THE SEPARATION ROLLER
10:Install the orange tool in the separation roller until it snaps into place.
11:Slide the roller to the left.
12:Tilt the end of the tool down (callout 1), and then pull straight out of the printer (callout 2) to remove the separation roller.
13:Remove the orange tool from the separation roller.
14:Locate the pickup and feed rollers.
15:Locate and pull down the blue tab to unlock the pickup and feed rollers.
16:Use the blue tab as a handle to slide the rollers to the left to compress the left blue post until it clicks into place.
17:Slightly move the rollers to the right to free them from the blue post. Make sure that the roller is clear of the black post on the right.
18:Slightly lift up the front of the roller assembly (callout 1), and then pull the assembly away from the printer (callout 2) to remove it.
19:If the left post does not stay in the locked position, press the end of the post left until it clicks into place.
1:Align the arrow on the roller assembly with the arrow in the printer, and then slide the rollers into the printer.
2:Slide the rollers to the right onto the black shaft.
3:Confirm correct installation: The white hook on the top of the roller assembly (callout 1) will hook onto a sheet metal plate (callout 2) when installed correctly.
4:Locate the lever on the blue shaft on the left, and then release the lever by pressing upward.
5:Remove the orange tool from the roller assembly by pulling it away from the printer.
6:IMPORTANT: Pivot the tab up and snap it into place against the rollers to correctly lock the rollers in place.
7:Install the orange separation roller tool onto the replacement separation roller.
8:When installed correctly, the embossed arrow on the roller case aligns with the white tab on the rail.
9:Do the following:
ALIGN THE ROLLER AND SLIDE IT ONTO THE METAL SHAFT UNTIL IT SNAPS INTO PLACE
10:Remove the orange tool by pulling it away from the printer.
Due to image upload restrictions, please refer to the attachment for a detailed installation manual.