Creates Daytime Privacy, Let You Enjoy Your Life Easily and Safely During Daytime!

Why Choose HooTowns One Way Window Film?

● This window film added UV solvent layer, can effectively block 97% of ultraviolet rays, provides an excellent UV blocking barrier.

● You can enjoy your good time in your room or living room, immersed in the afternoon tea and sun bath without worrying about the eyes outside the window.

● You will feel very good when you can see outside and outside cannot see you, after applying the window tint, outside glass shows mirror reflective effect, it gives you more privacy from nosy neighbors.

● The window film effectively resist external heat, save the cost of air conditioning costs, insulates heat in summer and cold in winter. Let you and your family enjoy a more comfortable indoor life.

● Our window tint can against all kinds of harmful light, protect your skin and eyes, reduce glare, prevent your precious furniture from fading, keep your home more cool and comfortable.

● If you are looking for a way to have some privacy and cut down on the heat from the sun. This has been just what you wanted.

QUESTION & ANSWER:

Q1: Why did my window film fall off after a day?

A1: Maybe the transparent backing film wasnt peeled off, please remember to peel the backing off before applying, and apply the smooth side to the window glass.

Q2: Any good way to smooth out the air bubbles?

A2: Spraying a lot of soapy water is the key point, spray generously! Water makes it easier to smooth out the air bubbles.

Installation Instructions:

● Please follow the instructions to apply the privacy window film, its the easiest way to do it.

Recommended Tools: Squeegee, Spray Bottle, Measuring Tape, Stainless Steel Ruler, Scraper(Credit Card), Lint Free Towel.

Step 1: Clean Your Windows - Use a squeegee to clean the windows, make sure your windows are thoroughly cleaned.

Step 2: Measure Windows Size and Cut Film - Cut the film 1 inch longer and wider than window.

Step 3: Remove Protective Liner and Spray Soapy Water - Spray your film with soapy water, during the film separation process.

Step 4: Wet the Window Well with a lot of Soapy Water.

Step 5: Apply the Film Against Glass - Make sure you spray both the window and the film with enough soapy water before applying it.

Step 6: Squeegee Out All Bubbles - Spray a bit of soapy water on the window film, the soapy water helps the squeegee slide easier. Use a solid squeeze to apply film and eliminate bubbles, from center to end.

Step 7: Cut Off Excessive Film.

Step 8: Seal & Dry - Spray over applied film again, wipe with a lint free towel.

Some Warm Tips:

1. The window film can only suitable for flat, smooth and clean glass. Most important is to make sure that your window is thoroughly clean, every little speck of dirt may create a bubble;

2. Do not pull the backing off the window film until you are absolutely ready to use the film. Dust may cause the film difficult to stick. As you peel the backing off, do so smoothly and slowly as to not cause any creases. Bubbles you can get out, creases you may can not;

3. When applying the film, please cover all the glass surface to avoid light leakage. This may cause the glass to crack after being unevenly heated;

4. Please do not use the window film if the temperature difference between indoor and outdoor is large (it is recommended that the temperature difference be controlled at about 30 degrees); Do not use laminated glass.