[Spot Beam Black Finish]
[Flood Beam Black Finish]
[Spot Beam White Finish]
[Flood Beam White Finish]
Multi-voltage: 10-30 VCD
Number of LEDs: 16
Power Consumption: 80 W
Luminous Flux: 8000 LM
Beam Pattern: Long-Range Spot Beam
Ambient Temperature: -40°C to +50°C
Dimensions: 4.8” W x 3.6” H x 3.1” D / 122 x 92 x 80mm
Connection: Pigtail Wires
Approvals: CE EMC approved, compliance 47 CFR FCC Part 15 Subpart B ANSI C63.4: 2014, IC CAN ICES-5 (B)/NMB-5(b),
Weight: 7.0lbs
1. Switch: Press the button, turn on/turn off R02 Search Light.
2. SOS Distress Signal Button: Press the button, the light would flash as the SOS signal, 3 long flash-3 short flash.
3. Upward: Press the button, the light will turn up. Keep pressing the button, the light will keep rotating upward (clockwise 110 degree).
4. Downward: Press the button, the light will turn down. Keep pressing the button, the light will keep rotating downward (anticlockwise 110 degree).
5. Left Button: Press the button, the light will turn left. Keep pressing the button, the light will keep rotating left (anticlockwise 360 degree).
6. Right Button: Press the button, the light will turns right. Keep pressing the button, the light will keep rotating right (clockwise 360 degree).
1 x Spot Beam 80W LED Search Light
2 x Wireless Remote Controller
4 x Screws
1 x LED Search Light Operating Instruction
|
|
|
---|---|---|
Please Note:As the remote controller works normally without coding, the search light can be controlled by any remote controller. If you need one-to-one controll, please code the light. |
How to codeConnect the light to 10-30V direct current. After the light turns on, take the remote controller, press the switch button (ON/OFF) within 30 seconds (more than 1min will be invalid), and keep pressing for 6 seconds until the light flash 3 times (long flash). Then coding succeed. |
How to Lift Code1. After the light turns on, take the remote controller which already coded with the light, press the switch button (ON/OFF) within 30 seconds (more than 1min will be invalid), and keep pressing for 6 seconds until the light flash 3 times (short flash) and the light turns off automatically, then code lifting succeed. 2. After the light turns on, take any remote controller (no matter whether already coded with the light), press the switch button (ON/OFF) within 30 seconds (more than 1min will be invalid), and keep pressing for 6 seconds until the light flash 3 times (short flash) and the light turns off automatically, then code lifting succeed. 3. The light can re-code with any other remote controller after code lifted. 4. While the process of code lifting, if the light is under SOS flashing condition, it will stop flashing immediately. (P.S, totally 30 seconds including the 6s keep pressing period). |