Feature(may vary by option.)
●Fitment:Fits for 1995-later FLHR, FLHRC and FLHRS and 2014-later FLHRSE models. Also fits 2006-2013 FLHT, FLHTC, 2006-later FLHX and FLHXS and 2019-later FLHT models
●Made of Steel, with Chrome Finish,Deflectors Attach to the Fork Brackets for a Clean and Integrated Look
●NOT Fit for Models Equipped with Fairing Lowers. NOT Fit for 1995-2013 models equipped with Lighted Fork Slider Kit or Custom Auxiliary Lighting Bracket Kit P/N 69227-04A or 68000043
●Sold in Pairs without Bolts,Note:Modifications or Adjustments May be Required on Passing Lights/Turn Signals for Better Installation.
●After installation, if deflectors hit the crash bars and would not allow the bars to turn more than 20 degrees.Please adjust the impact bar properly and bend the deflectors out until they no Longer make contact,or try to switch the Left and the right sides.For other cases, please refer to the description on this product details page.
[Chrome]
[Black]
Description
Fitment:
Fits 1995-later FLHR, FLHRC and FLHRS
2014-later FLHRSE models
2006-2013 FLHT, FLHTC
2006-later FLHX and FLHXS
2019-later FLHT models
# Does not fit models equipped with Fairing Lowers.
# Does not fit 1995-2013 models equipped with Lighted Fork Slider Kit or Custom Auxiliary Lighting Bracket Kit P/N 69227-04A or 68000043.
Adjustments
-If deflectors Hit the Crash Bars and would not Allow the Bars to Turn More than 20 Degrees? (2014-up Road King Models May Notice)
Solution 1 To Bend the Deflectors out until they No Longer Make Contact/Solution 2 Try Switching the Left and the Right Sides.
-If Connector for the Directional Lights is too Big to Fit?
Solution: Theres a Small Flange on the Connector that Binds on the Hole. Clipping or Filing off the Flange Allows it to go through Fine and has No Effect on the Connector.
-How to Adjust Auxiliary Lights/Turn Signals?
Solution:Unscrew the Two Allen Screws Holding Each Turn Signal on, then Completely Unscrew the Nut up inside the Aux Light Housing in Order to Move between these Notches.
A 9/16 Socket is Needed, Get a Deep Socket, Cut a Vertical Notch into the Socket where the Cable can Fit in (Allowing you to Get it up in and around this Nut inside the Aux Light Housing).
After Moving Aux Lights/Signals to the forward Notch, this Wind Deflectors Fit Perfectly with Room to Spare behind the Turn Signals.