How to Remove the Dents?
1. Clean the damaged surface with a clean wet cloth.
2. Insert the glue stick into the 100W glue gun, then heat it for about 3-5 minutes.
3. Pull the trigger and apply the suitable glue tab with extruded glue.
4. Put the tab on the dent, hold on and wait for a minute until the hot melt glue is a clod.
5. Use a golden dent lifter or bridge puller to align, tighten the screws, and slowly squeeze the handle or pull up the dent until the desired result is achieved.
6. Spray 75% rubbing alcohol all over the residual glue, wait for 1-3 minutes. Peel it off or remove it with a plastic shove.
7. If a dent still exists, please tap lightly with a rubber hammer and a tap-down pen.
8. Repeat the operation steps above until the dents are repaired.