Feature

●How to Use the Dent Repair Tools Clean the dent with a clean wet cloth; Mount the glue stick into the glue gun,pull the trigger to let the glue stick into the glue gun, connect the power source and preheat for 5 minutes(Note: Glue not included.You need to buy the Hot Glue by yourself)
●Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is)
●Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue);Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter)
●Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;(Note: :The 18 gaskets are all made of hard plastic and have no suction itself. It is necessary to melt the glue stick with a hot-melt glue gun and apply it to the gaskets for use)
●Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen; Clean the repaired place with a clean wet cloth


Description

Dent puller operation skills 1. The gasket should be stuck to the bottom of the concave, not to the concave wall, otherwise it is easy to come unglued.Puller gaskets are plastic gaskets with no suction. 2. The gasket can not tilt pull, otherwise it is easy to come unglued. 3. If the dent is large, do not stick the gasket directly in the middle of the dent, but from the concave edge to the middle of the operation. Dent puller adhesive skills 1. Power on the glue gun and heat the glue stick fully. After melting, drop the glue on the gasket and stick to the car body quickly, because the solidification time of the glue is very fast. 2. Blow the sheet metal with a hair dryer to keep the temperature of the sheet metal, immediately stick the gasket coated with glue, and wait for about five minutes to operate. Description It is made of aluminium alloy for strong strength and long durability body repair dent removal tools. Used as a adapter for slide hammer or pulling tap for easy catching and pulling car dent repair tool. a necessary component for dent repair, direct replacement for the broken one. Easy installation, the thread size is M10 for better application auto body tools. 100 percentage Brand new and quality auto dent remover. Material: Aluminum Alloy Type: M10 Warm Tips: May not work well with dents that are not mostly flat.Package Included 1pcs x Slide Hammer 18pcs x Blue Glue Tabs