Product parameters
Module power supply voltage: 2V-10V
Signal input voltage: 1.8-7V
Single circuit working current: 1.5A
Peak current: up to 2.5A
Low standby current: less than 0.1uA
Product size: 24.7 * 21 * 5mm/0.97*0.83*0.20in (L*W*H)
Installation hole diameter: 2mm/0.08in
Features
Built-in anti-common state conduction circuit, the motor will not malfunction when the input end is suspended
Equipped with a built-in overheat protection circuit (TSD) with a hysteresis effect, there is no need to worry about motor stalling
Dual H-bridge motor drive, capable of simultaneously driving two DC motors or one 4-wire two-phase stepper motor
Adopting imported original professional motor driver chips, with built-in low conductivity and internal resistance MOS switch tubes
With minimal heat generation, no need for heat dissipation fins, small size, and low power consumption, it is an ideal choice for your battery power supply
Built-in overheat protection circuit, there is no need to worry about the motor being blocked or burnt out. It automatically recovers after the temperature drops
Small size, lightweight, and low standby current is the ideal choice for car module
Replace L298N very well
Suitable for battery-powered smart cars, toy cars, robots, etc
Precautions
The reverse connection between the positive and negative poles of the power supply will definitely cause circuit damage
In the case of a short circuit to the ground or output terminal, as well as motor blockage, the chip will be thermally protected. However, it can also cause chip burnout when the voltage is close to or exceeds 10V and the peak current greatly exceeds 2.5A