Feature

●SLOWS TROLLING SPEED - Slow your boat to as low as 1 MPH for the ideal trolling speed
●DAMAGE-RESISTANT DESIGN - The patented hinged plate design flexes upward to prevent damage to the plate under accidental acceleration
●EASY INSTALLATION - Mounts directly to the cavitation plate of your outboard or outdrive, a few inches behind the propeller
●TWO MODELS TO FIT YOUR MOTOR - The Standard Model fits outboard and stern drive motors of 50-300 horsepower, while the Short Model is for 30-45 horsepower outboard motors
●OPTIONAL FINS FOR GREATER PERFORMANCE - The optional hydrofoil trolling plate model combines two products into one to improve fuel economy and performance
●BUILT TO LAST - The EasyTroller is made in the USA from marine-grade anodized aluminum and stainless steel and backed by a one year manufacturers warranty


Description

EasyTroller Standard - Mounted with Plate Hinge ActuatedEasyTroller Standard - Mounted with Plate Hinge Actuated

Ready to Troll

Slow your boat to the ideal trolling speed with the EasyTroller trolling plate. Rugged aluminum components and hinged plate design help prevent damage to the plate in case of accidental acceleration. Models available with or without fins.

The EasyTroller difference

Typical trolling plate stress pointTypical trolling plate stress point

EasyTroller trolling plate flexes under stressEasyTroller trolling plate flexes under stress

Model with hydrofoil finsModel with hydrofoil fins

Eliminate damage caused by accidental acceleration

Under power, prop thrust can bend or damage the typical trolling plate as water is forced upward.

EasyTroller flexes under pressure

The EasyTroller trolling plate flexes to divert the prop thrust downward, preventing damage to the plate.

Hydrofoil fins combine two products in one

Choose a model with hydrofoil fins to improve your hole shot and help prevent porpoising.

EasyTroller Standard with Fins EasyTroller Standard with Fins

Using EasyTroller

  • Tie off the release cord with enough slack for plate to go down and prop to turn
  • Pull the cord and the plate will move into the down trolling position
  • The plate will lock into place when properly seated, slowing the boat’s trolling speed
  • Release the EasyTroller plate by pulling on the cord with the motor idling and in forward gear
  • Accelerate slightly and the plate should raise and lock into the up position

Proudly made in the U.S.A.

  • EasyTroller Standard Model fits outboard and stern drive motors 50-300 horsepower
  • EasyTroller Short Model fits outboard motors 30-45 horsepower
  • Reduce trolling speed to as low as 1 mph
  • Hinged plate flexes upward to prevent damage to the plate
  • Manufactured from marine-grade anodized aluminum and stainless steel

Easy Troller - standard and shortEasy Troller - standard and short

Dont forget!

  • EasyTroller should always be in the up position when running at speed
  • EasyTroller should be set in the down position when transporting your boat on a trailer

Installing the EasyTroller

  • Can be mounted on top or underneath the cavitation plate
  • Position the EasyTroller 4-7 inches from the prop, then clamp in place
  • Drill 5/16" holes through the cavitation plate and mount with included hardware

Mounts under or on top of cavitation plate

Standard model in up positionStandard model in up position

Product information