Feature

●Nucleus-M Motor and 55cm 7-Pin to 7-Pin Nucleus-M Motor Cable included.
●To power the motors, only one power port on your camera rig needs to be used. Simply plug the P-tap power cable into one of the motors and then daisy chain power to the rest of the motors with the short 7-pin to 7-pin cables. The motors can be powered through a power source that has a voltage output ranging from 7.2V-24V.
●The motors are designed to clamp onto 19mm or 15mm rods (with the included rod bushings). This clamp-on design allows you to easily attach and detach the motors without needing to remove any other accessory from your setup.
●The motors are designed to clamp onto 19mm or 15mm rods (with the included rod bushings). This clamp-on design allows you to easily attach and detach the motors without needing to remove any other accessory from your setup.
●The motors allow for automatic calibration of the lens as well as manual calibration if you are using lenses that don’t have hard end stops at close focus and infinity.


Description

This Nucleus-M motor kit allows you to add a motor to your Nucleus-M kit along with the 7-pin to 7-pin power cable that allows you to power the motor from a daisy-chained connection to another Nucleus-M motor.
Each motor has its own built-in motor drive that communicates directly with the hand unit and hand grips. This negates the need to mount a separate MDR to your rig, allowing for a more compact camera setup and a quicker setup time. Simply set the motors and hand unit/hand grips to the same channel and you will have full control.
The motors are designed to clamp onto 19mm or 15mm rods (with the included rod bushings). This clamp-on design allows you to easily attach and detach the motors without needing to remove any other accessory from your setup.
[NO MDR NEEDED] Wirelessly Control the Motors Up to 1000 Feet
[RUN STOP CAPABLE] via Optional Camera Specific Run Stop Cables
[MANUAL CALIBRATION] Supports Lenses With and Without Hard Stops
[COMPATIBLE] with Most Cinema Lenses via the Motors 0.8 Gear Pitch or
[UNIVERSAL ROD MOUNT] Supports 15mm and 19mm Rods
PACKING LIST:
(1) Nucleus-M Motor
(2) 55cm 7-Pin to 7-Pin Nucleus-M Motor Cable