Soldering Steps
Step 1: Install 20pcs SMD 0805 Red LED at LED1-LED20. It is negative pole for
LED where there are green mark on LED pin. The ellipse pad is negative pole on PCB that
shall connect to negative pole for LED.
Step 2: Install 1pcs SOP-8 LM358 at U1.There is a smaller dot on one corner of
the IC and there is a white dot on PCB where the IC can place on.These two marks are
corresponding to each other and are used to specify the installation direction of the IC.
Step 3: Install 1pcs SOT-23 S8050 Transistor at Q1.
Step 4: Install 1pcs 22ohm SMD 0805 Resistor at R5.
Step 5: Install 1pcs 33Kohm SMD 0805 Resistor at R6.
Step 6: Install 3pcs 47Kohm SMD 0805 Resistor at R1,R2,R4.
Step 7: Install 1pcs 100Kohm SMD 0805 Resistor at R3.
Step 8: Install 1pcs 47uF SMD 0805 Capacitor at C1.
Step 9: Install 1pcs 9V Battery Box.
Step 10: Connect to power supply and enjoy the effect.