Feature
●10 Wattage and 150 Ohm, 5% tolerance. Wire Wound Resistor owns high stability and accuracy. Moreover, it was used for various application because of the wide resistance range.
●Aluminum Housed. An insulated cover on the wounded wires would block out the heat, which promises the high performance of a resistor. Hence, the cooling job was achieved by aluminum case.
●This 10W resistor formed with qualified copper, nickel, and aluminum. With the compact structure and heat dissipation design, a capability of overload has been built.
●Board length 3/4 inches(19mm) and two rods with 1.8mm hole for a soldering connection. Dia. 2.5mm antisymmetric anchoring hole for holding, which will fit #2 Screws(or M2.3 nuts)
●Reliable. Problems like the flush LED would have a perfect solution, or you can use it in any AC DC circuits, converter, inverter, motor speed control, drivers, etc.
Description
Specification:
- Material: Nickel Alloy Wire Wound Resistor with Aluminum Case
Reliable. Problems like the flush LED would have a perfect solution, or you can use it in any AC DC circuits, power supply, frequency converter, inverter, motor speed control, drivers, etc.
- The load resistor will get huge hot, please dont touch it when the resistor is working.
- The load resistor should be mounted on metal board, not on flammable board such as plastic board,rubber,paper,wood and etc.
- Not recommend to use it for Automotive repair or refit unless you have professional knowledge.
- We recommend a 30%-50% increase in rated power based on your actual load power and add a heat sink device when it is necessary.
