Table Inserts (pack of 2), new bandsaw aluminum table inserts for Delta 14" (LBS-56) and most import bandsaws.
OLD Delta number LBS-56
Make sure your insert recess has the locating pin on the rear, not on the side. 2&1/2" X .100 thick. Please measure your saw as some Delta & Rockwell 14" bandsaws has slightly smaller holes for the throat plate. If so some slight filing or sanding may be required.
IMPORTANT INSTALLATION NOTE::I have sold several hundred of these and occasionally someone will have the problem of it being a bit too large.First make sure the lip of the hole is free from dirt. If a table alignment pin, (located in the blade slot on the right side of the table), is not tight or missing, often the blade mounting slot will close up some over time which reduces the hole diameter slightly. I tap a flat head screw driver into the blade installation slot a bit to wedge it open. That should spread the insert hole enough for it to fit

Fits the following Delta 14"saws:
28-141, 28-200, 28-203, 28-205, 28-207, 28-209,28-216, 28-230, 28-231, 28-240, 28-241, 28-243, 28-245, 28-248, 28-254, 255, 28-262, 28-263, 28-269, 28-270, 28-275, 28-278, 28-280, 28-283, 28-285, 28-290, 28-293, 28-299, 28-300, 328-03, 28-306, 28-345, 28-348, 28-350, 28- 365, 28-366, 28-380, 28-475, 28-651, 28-652, 28-653,28-654,28- 656, 28-662 and others.Interchanges with Delta part number 426020630001
Replaces 426-02-063-0002