All in 1 Pool Cue Tip Shaper

Product Instructions

If you dont know anything about tips and using this tool,please read carefully as below:

you need to prepare a new tip and a bottle of glue before using it,you can use a cheap cue tip or old cue to practice to ensure success when you are the first time to do this ,Once you understand how to use it and how to change a tip this truly is a one-stop tool.

1,Tape off your ferrule with masking tape, this will help you avoid extra glue.

2,Be careful cutting the tip off ,Use blade on side of the tool or you can use another razor blade for extra control but don’t get to close to the ferrule.If the tip doesnt cleanly removed,please use the cue repairing kit blade to remove the residual.

3,Use the circle hole (diameter control loop) to shave off the remaining tip and glue on the ferrule.

4,Sand the new tip side that will be glued,ensure the tip surface to be flat.

5,Glue the tip on and be careful to make it even.Hold it down and wait for it to dry (it dries very fast but give it 15-20mins to be safe).

6,Start by trimming the top of the tip on an angle, it will make the final shaping way easier.

7,Carefully trim the sides to be flush with the ferrule. (you can use the main blade of the conical holes to remove extra diameter of the tip,just change the angle of the cue,parallel the taper hole and cue,clockwise rotate) Remove the tape to ensure flushness, then put back on to avoid unwanted debris.

8,Use the curved sand board to shape it to a nickel or dime. This will take a while but be patient.

9,Use the 2 kind of radians alignment to choose the radian what you need,If there is a gap that means the tip radians is not uniform,need further burnish.

10,Use the needle to scuff and poke the top and add some chalk to enjoy your game.