Feature

●Widely used - Suitable for most dents, repair door dings and hail damage and other dents. Efficient action on automobile, refrigerator, washing machine and other metal surface dents.Note: This dent puller is effective on thin metal surfaces and is not suitable for metal surfaces exceeding 3mm. Applicable dent area: 1.2inch-3.9 inch.
●Physics design - Using the principle of leverage to design the dent puller is ergonomic, the dent bridge puller with a unique arched bridge can adjust the spacing and rotate the button to better fit the dents, the efficient and labor.
●Package information: 1 x Sliver bridge dent puller,7 x Dent Puller Tabs, 1 x Mini Hot Melt Glue Gun,5 x black hot melt glue sticks,5 x yellow hot melt glue sticks,2 x Rubber Scraper,1 x Alcohol Spray Bottle（empty）,1 x black cloth.
●Satisfactory service: Welcome to contact us, we will answer customer information within 24 hours. Customers have the right to choose a refund or replacement if the product does not work.
●Tip: Please read the product instructions and manuals carefully before using. The product is not suitable for spinal shape cracks on the metal surface. Please feel free to contact us if you have any question.

Description

Step 1.Clean dent surface.

Step 2.Put the glue sticks to gun and heat, connect the power source and preheat for 5-10 minutes.

Step 3.According to the dent size to choose the Glue Puller Tab, then put the heated glue on puller tab, immediately place puller tab in the center of the dent and hold on until it sticks.

Step 4.Let the glue cool for about 5-8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter.

Step 5.After the glue cooling,use a golden dent lifter or bridge puller to align and press the puller to pull up the dent. Repeat the above steps until the dent disappear.

Step 6.After finishing the dent,use the alcohol or hot water to clean the glue which on the car and the puller tabs.

If the repair fails, please repeat the operation until it is repaired.

Tips

If there are still raised points on the repaired surface, perform the following operations:

1. Press the raised point back and forth with your thumb until the surface of the raised point is flat.

2. If the raised point cannot be flattened by pressing the thumb, you can try to align the raised point with a leveling pen (the usual holding position of the pen) and gently knock it with a rubber hammer until the repair is smooth. If the repair fails once, you can repeat the operation many times until the repair is successful. (Pay attention to the strength of the pro when knocking oh, too much may have a negative effect)

The following conditions cannot be repaired

1. If the car has been repainted, broken, severely scratched or cracked, this tool cannot be used, because the glue will stick the paint off.

2. Depressions like some slender strips cannot be repaired because the traction pads are not firmly adhered to the depressions.

3. The product is not suitable for spinal shape cracks on the metal surface.

Package Included:

1 x Sliver bridge dent puller 7 x Dent Puller Tabs

1 x Mini Hot Melt Glue Gun 5 x black hot melt glue sticks

5 x yellow hot melt glue sticks 2 x Rubber Scraper

1 x Alcohol Spray Bottle 1 x black cloth

Tips

Package Included:

Product information