Feature(may vary by option.)
●【Super performance】 Use high brightness LED chip, high light transmission three-layer combination of lights, very bright light output, very low power consumption, higher quality laser etched projection glass to ensure clarity never fade, never blur
●【Easy Installation】Plug and Play! No drilling, no wiring, no disassembly, no damage to your car, just use this screwdriver to gently pry open the original light and replace it. (It only takes about 1 minute to install each Volvo door marker light.) Note: When you want these marker lights as replacement lights, please make sure your car has the original door lights first.
●【High quality material】Waterproof, shockproof, high temperature resistant, corrosion resistant, can work in -40℃~105℃ environment Rugged and durable, better protect the lens and internal chip circuit. New grid heat dissipation design, effective discharge of internal heat to extend service life
●【Product Function】 Use car welcome projector light, when the door is open, LOGO in the open door surface lights up, providing light to assist in entering and exiting the vehicle to remind others to avoid mistakenly get out of the car, so that the owner can not see the road under the feet to avoid puddles or other obstacles on the ground.
●【Compatibility】LED Door Lights Logo Pojector is compatible with Volvo 2015-2023 XC90/2018-2024 XC60/2017-2024 S90/2020-2024 S60/2017-2024V90/2020-2024 V60/2018-2024 XC40. in Please make sure your car matches the description before you buy and place your order, (please refer to the description photos)
[Type A LOGO]
[Type B LOGO]
Description
LED Door Lights Logo Pojector
2015-2023 XC90
2018-2023 XC6
2017-2023 S90
2020-2023 S60
2017-2023 V90
2020-2023 V60
2018-2023 XC40
Super performance
Use high brightness LED chip, high light transmission three-layer combination of lights, very bright light output, very low power consumption, higher quality laser etched projection glass to ensure clarity never fade, never blur
It just take you a little while to install
|
|
|
|
|
|---|---|---|---|
Step 1:Use a screwdriver to pop out the original light carefully. |
Step 2:Push down the clip to remove the wire. Notice: Do not let go of the cable. |
Step 3:After removing the original lamp, plug in the projection lamp |
Step 4:Finally the projection light will be installed on the car door |
Product Function
Use car welcome projector light, when the door is open, LOGO in the open door surface lights up, providing light to assist in entering and exiting the vehicle to remind others to avoid mistakenly get out of the car, so that the owner can not see the road under the feet to avoid puddles or other obstacles on the ground.