While the installation is different for the specific make and model of mud flap, You can refer to the general steps for installing mud flaps as follows.
Step 1: Clean the wheel area. Clean the area where the mud flaps will be installed.
Step 2: Create space between the tire and wheel well. Turn the front wheels to the left fully for the most clearance between the tire and wheel well.
Step 3: Check for placement. Test that the flaps will work for your vehicle by holding them up and comparing them to the shape and fit of the space available and checking for a "RH" or "LH" mark for proper placement.
Step 4: Locate the holes. Your vehicle should have holes factory drilled into the wheel well for these mud flaps to work. Locate these holes and remove the screws that are currently in place.
Step 5: Put the flaps into place. Move mud flaps into place and reinstall screws into the holes in the wheel well to install mud flaps, without fully tightening.
Step 6: Tighten the parts. Adjust placement and angle of mud flaps and fully tighten parts.
Step 7: Install any extras. Install any additional screws, nuts,or bolts that may have come with the mud flaps.