Installation procedure & precautions:

1. Remove the plastic cover

It should be noted that the cover is divided into two parts, and the right side of the lower part is set on the ignition switch, which can be taken off after it is removed.

2. Remove the ignition switch

Prepare a screwdriver, you can see the screw eyes above the light pole and the wiper pole, one on the left and one on the right. If you only change the lock core, you can also not remove the ignition switch, but if you do not remove the lock core, you should pay attention to one point when installing the lock core, otherwise the lock core will not be inserted.

3. Unplug the ignition switch

There is a clip on the plug. Take it off first.

4. Remove the lock core

This lock core can not be screwed off, can not be pulled off, there is a mechanism. Turn the key into "B" and pull it off.

Mounting of lock core

1. The key into the lock core, screw to "I" file.

2. Press the metal block on the ignition switch surface. If the ignition switch is not removed, it is pressed to the metal block, then use a screwdriver larger than the size of the rod in the lock core to insert the ignition switch and pull down

3. insert the lock core into the beginning of the ignition, until you hear the sound of the lock core surface clip again, screw back to the "B" file.