How to Install?
1. Loosen assembly screws in face and separate device. If needed, back out cord clamp screws enough to allow the cord to fit between the two clamp halves. Insert cord through cord clamp and housing. Simply remove the minimum cord clamp if the cord dia. is 0.391"-0.655".
2. Strip cord jacket between 7/8” and 1” from cord’s end. Remove insulation exposing between 3/8” and 1/2” bare copper wire (see diagram 1a). Twist
wire strands tightly together. Trim off cord fillers, if any.
3. Insert bare copper wire into wire clamp and tighten each terminal screw 10-12 in-lbs. torque. Ensure insulation clears clamp; HOT conductor to BRASS terminal, NEUTRAL conductor to SILVER terminal, and GROUND conductor to GREEN hex screw.
4. Assemble wired device body with housing. Align keyed housing with a key on the device’s body. Tighten assembly screws.
5. Alternately tighten cord clamp screws 10-12 in-lbs. torque. Ensure cord clamp rests over cord jacket, not over conductors.
Note:
Built-in cord grip adjusts automatically for use with 18-12 AWG.