[BTT SKR MINI E3 V3.0 Silent Board]
[SKR MINI E3 V3.0+TFT35 E3 V3.0.1]
Introduction
BIGTREETECH SKR MINI E3 V3.0 is a motherboard specially designed for Ender3 printers launched by the 3D printing team of Shenzhen Biq Technology Co., Ltd. It perfectly replaces the original Ender3 printer motherboard. support running Marlin/Klipper firmware.
Appearance size: 103.75*70.25mm
Layer: 4 layers
MCU: ARM Cortex-M0+ STM32G0B1RET6
Power input: DC 12/24V
Logic voltage: 3.3V
Motor Driver: Onboard TMC2209 in UART mode;
Motor drive interface: XM, YM, ZAM, ZBM, EM
Temperature sensor interface: TH0, THB, 2-way 100K NTC (thermal resistance)
Display: 2.4-inch TFT, 3.5-inch TFT, Ender3 original LCD12864 screen, etc. PC communication (run Klipper, if you want touch mode, select HDMI5/7, TFT35 SPI display)
Interface: USB Micro B type, easy to plug and unplug
Supported file formats: G-code
Recommended software: Cura/Simplify3D/pronterface/Repetier-host/Makerware
Motherboard firmware description
1. The factory motherboard will be equipped with the firmware used for testing (Ender3 model), which can be used directly or modified according to your own needs.
2. To update the motherboard firmware, select the firmware.bin file in the compiled firmware package and copy it to the root directory of the SD card. Note: The file name cannot be changed, firmware.bin must be in lowercase! Insert the SD card into the SD card slot of the motherboard, power on again or press the reset button. The red status indicator light will flash during the firmware update process. Wait for about 10 seconds before the update is completed; 3. For motherboard firmware DIY, please refer to Github: BTT SKR MINI E3 V3.0_PIN.pdf information
Precautions:
1. The name of the firmware file in the SD card cannot be changed and must be firmware.bin (including upper and lower case)
2. The wiring process must be carried out under the premise of